|
|
|
|
|
|
|
|
|
|
|
|
|
|
This tool is needed sometimes to remove a nozzle or tube plug from a fitting. One of these is included in each turn key system package
|
This part is necessary if you want to change your nozzle from a Hago to a cleanable 1024-3010 nozzle. One end has a male thread just like a Hago nozzle and on the other end it has a female 1024 thread to receive a male threaded slimline nozzle. All you do is use a 5/8" wrench and a 3/4" wrench to remove the existing Hago nozzle tip. Then screw in the Hago - slimline adapter. Then screw in your 1024-3010 cleanable nozzle assembly hand tight and your done. Now you can easily remove and clean your nozzles if they become clogged.
|
This tool allows smooth straight cuts when installing your system. One of these is included in each turn key package.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
This shut off valve has push to connect tube fitting connections on both ends. This can be used when you want to turn off a section of your system. ie a patio where you might be entertaining so you won't have to shut off the entire system.
|
This brass fitting screws on to your water faucet and has a 1/4" push to connect female connection so you can connect your 1/4" flexible tubing line from your water faucet and run it to your machine. This item is included with every machine.
|
This shut off valve has 3/8" push to connect tube fitting connections on both ends. This can be used when you want to turn off a section of your system.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1/4" Push to connect cleanable Polishing Filter with viton seals. Install this at the beginning of your nozzle circuit to reduce nozzle clogs. This can be used as a water filter.
|
3/8" Push to connect Cleanable Polishing Filter with viton seals - nickle plated brass. This can be used as a water filter.
|
This is a push to connect fitting that only allows fluid flow to go one way. If you have a tank system and you spring a leak under ground, this will keep your fluid from siphoning out of your barrel.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
This is a push to connect fitting that only allows fluid flow to go one way. If you have a tank system and you spring a leak under ground, this will keep your fluid from siphoning out of your barrel.
|
Mosquito Misting nozzle Filter replacements for slim line nozzles (100 pc. Pack)
|
Copper mosquito misting nozzle riser 24" tall with Tee and plug.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
180" 418 MHZ, antenna cable extender for increased remote control range.
|
Nylon Barrel cover for 55 gallon tank Mosquito system
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
This fluid level switch plugs into our MosquitoMax plug and play controller and will detect when your tank is low on fluid. If integrating this switch with an existing barrel system, you will need to measure the correct length so that the switch will trip before the water level is below your suction tube. It comes with a weight that should be attached to your suction filter and zip ties to fasten the cable to your suction line.
|
8 button wireless transmitter for MosquitoMax misting systems. See operators manual for instructions on learning a remote to an existing machine.
|
|
|
